Fractal Design Tower Raiser (3346537)
Item Preview
Pretty simple stuff to raise the heavy tower and enable to use the hoover to remove the dust underneath.
The part need to be pretty strong to handle the weight of this puppy.
I used this trick: you can use your regular 0.4mm nozzle and set the extrusion width to 0.8mm ^^
I used 2 Perimeters, 30% Strong Hex Infill, 5 Top/Bottom Layers at 0.25mm using my trusty ChopChop3D Slicer (https://www.chopchop3d.com), it takes about 3 hours at a slow speed for each foot. I used higher temperature than usual and no fan cooling.
Strong Hex Infill is not your regular Hex Infill (checkout the image to see how biffy it is ^^)
The part need to be pretty strong to handle the weight of this puppy.
I used this trick: you can use your regular 0.4mm nozzle and set the extrusion width to 0.8mm ^^
I used 2 Perimeters, 30% Strong Hex Infill, 5 Top/Bottom Layers at 0.25mm using my trusty ChopChop3D Slicer (https://www.chopchop3d.com), it takes about 3 hours at a slow speed for each foot. I used higher temperature than usual and no fan cooling.
Strong Hex Infill is not your regular Hex Infill (checkout the image to see how biffy it is ^^)
Reviews
There are no reviews yet. Be the first one to
write a review.
