A vortex attenuation device is presented which dissipates a lift-induced vortex generated by a lifting aircraft wing. The device consists of a positive pressure gradient producing means in the form of a compression panel attached to the lower surface of the wing and facing perpendicular to the airflow across the wing. The panel is located between the midpoint of the local wing cord and the trailing edge in the chord-wise direction and at a point which is approximately 55 percent of the wing...
Topics: NASA Technical Reports Server (NTRS), ATTENUATORS, CONTROL SURFACES, PRESSURE GRADIENTS, VORTEX...
This investigation was conducted to determine the radial extent at which aircraft mounted flow vanes or roll rate gyros can sense the circulatory flow field that exists around the lift induced vortex system generated by an aircraft in flight. The probe aircraft was equipped with wingtip sensors for measuring angle of attack and angle of sideslip, and with a fuselage mounted gyroscope for measuring roll rate. Analysis of flight test data indicated that the vortex was detectable at a lateral...
Topics: NASA Technical Reports Server (NTRS), AERIAL RECONNAISSANCE, FLIGHT TESTS, FLOW DISTRIBUTION, FLOW...
As part of a propulsion/airframe integration program at Langley Research Center, tests were conducted in the Langley 16-Foot Transonic Tunnel to determine the effects of locating flow-through mixed flow engine nacelles in several aft underwing positions on the longitudinal aerodynamics of a high wing transport airplane. D-shaped inlet nacelles were used in the test. Some configurations with antishock bodies and with nacelle toe-in were also tested. Data were obtained for a free stream Mach...
Topics: NASA Technical Reports Server (NTRS), AERODYNAMIC INTERFERENCE, AIRCRAFT DESIGN, ENGINE AIRFRAME...
A means for extracting rotational energy from the vortex created at aircraft wing tips which consists of a turbine with blades located in the crossflow of the vortex and attached downstream of the wingtip. The turbine has blades attached to a core. When the aircraft is in motion, rotation of a core transmits energy to a centrally attached shaft. The rotational energy thus generated may be put to use within the airfoil or aircraft fuselage.
Topics: NASA Technical Reports Server (NTRS), AIRCRAFT EQUIPMENT, AIRCRAFT POWER SUPPLIES, ENERGY...
An exploratory investigation has been conducted at the Langley Research Center to determine the effect of a wing-tip-mounted pusher turboprop on the aerodynamic characteristics of a semispan wing. Tests were conducted on a semispan model with an upswept, untapered wing and an airdriven motor that powered an SR-2 high-speed propeller located on the tip of the wing as a pusher propeller. All tests were conducted at a Mach number of 0.70 over an angle-of-attack range from approximately -2 to 4 deg...
Topics: NASA Technical Reports Server (NTRS), INSTALLING, PROPELLERS, SEMISPAN MODELS, TURBOFAN ENGINES,...
The potential of laminar flow nacelles for reducing installed engine/nacelle drag was studied. The purpose was twofold: to experimentally verify a method for designing laminar flow nacelles and to determine the effect of installation on the extent of laminar flow on the nacelle and on the nacelle pressure distributions. The results of the isolated nacelle tests illustrated that laminar flow could be maintained over the desired length. Installing the nacelles on wing/pylon did not alter the...
Topics: NASA Technical Reports Server (NTRS), BOUNDARY LAYER TRANSITION, DRAG REDUCTION, LAMINAR FLOW,...
